Pressure - National Association for Proficiency Testing

KITS, Pressure

10,000 psi Digital Pressure Gauge

The purpose of the PRESSURE-1723 ILC/PT is to give organizations an opportunity to demonstrate their proficiency (e.g., use of appropriate equipment, procedures, ability to follow instructions) in the calibration of a Digital Pressure Gauge. This particular cage can use both types of media to drive the internal mechanisms.

Participants are asked to make 9 pressure measurements from 0 to 10,000 psi in ascending and descending set points. The resolution of the digital artifact is 1 psi. Pressure medium - use only clean, dry non-corrosive gases (pneumatic). The manufacturer specification for artifact accuracy is 0.1% FS (FS = 10,000 psi).

Participants are expected to be familiar with and have appropriate lab equipment and measurement uncertainties for calibrating similar devices.

Artifact in kit: Additel, ADT680, 0 to 10,000 psi

Show Details Inquire

KITS, Pressure

1,000 psi Digital Pressure Gauge

The purpose of the PRESSURE-1623 ILC/PT is to give organizations an opportunity to demonstrate their proficiency (e.g., use of appropriate equipment, procedures, ability to follow instructions) in the calibration of a Digital Pressure Gauge.

Participants are asked to make 9 pressure measurements from 0.0 to 1,000.0 psi in ascending and descending set points. The resolution of the digital artifact is 0.1 psi. Pressure medium - use only clean, dry non-corrosive gases (pneumatic). The manufacturer specification for artifact accuracy is 0.1% FS (FS = 1,000 psi).

Participants are expected to be familiar with and have appropriate lab equipment and measurement uncertainties for calibrating similar devices.

Artifact in kit: Additel, ADT680, 0 to 1,000 psi

Show Details Inquire

KITS, Pressure

-15 to 30 psi Digital Pressure Gauge

The purpose of the PRESSURE-1523 ILC/PT is to give organizations an opportunity to demonstrate their proficiency (e.g., use of appropriate equipment, procedures, ability to follow instructions) in the calibration of a Digital Pressure Gauge.

Participants are asked to make 11 pressure measurements from -13.0 to 30.0 psi in ascending and descending set points. The resolution of the digital artifact is 0.001 psi. Pressure medium - use only clean, dry non-corrosive gases (pneumatic). The manufacturer specification for artifact accuracy is 0.1% FS (FS = 30 psi).

Participants are expected to be familiar with and have appropriate lab equipment and measurement uncertainties for calibrating similar devices.

Artifact in kit: Additel, ADT680, -15 to 30 psi

Show Details Inquire

KITS, Pressure

25 psia Pressure Indicator

The primary purpose of the PRESSURE-1423 ILC/PT is to determine the appropriateness and effectiveness of the participant's methods, procedures, training and measurement uncertainty calculations relating to the measurement of Absolute pressures.

Participants will use their lab practices to perform 17 measurements across absolute & barometric pressure. Measurement values will be appropriate for the calibration of similar devices.

Participants are expected to be familiar with the operation and calibration of pressure indicators, have all necessary auxiliary equipment to support the measurement, and have measurement uncertainties appropriate for calibrating similar devices.

Artifact in kit: Mensor, CPG2500, 0 to 25 psia

Show Details Inquire

KITS, Pressure

1,000 psi Pressure Transducer (Pneumatic)

The PRESSURE-1318 ILC-PT program is intended to provide a means for laboratories to validate their calibration practice on a 1000 psi Pressure Transducer.

Participants are asked to make 10 measurements from 0 to 900 psig. This transducer has an uncertainty range of 0.006 psi on the lower part of the range to 0.22 psi at the higher end. Resolution is 0.001 psig.