Equipment & Tools for Sale

The primary purpose of this Force-924 is to determine the appropriateness and effectiveness of the participant’s methods, procedures, training, and measurement uncertainty calculations relating to the measurement of 100 lb Strain Load Cell.  This kit consists of ATO Strain Load Cell.

Participants are asked to make 20 measurements within both tension and compression.

Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.

Artifact in kit: ATO Strain Load Cell, DYLY-102

Participants will use their lab practices to perform 8 measurements of compression in the range of 2.5 Klbf to 25 Klbf. Measurement values will be appropriate for calibration of similar devices. The output is measured with a digital readout that is included. The expected uncertainty will vary depending on the calibration equipment used.

Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.

**TRAVEL KIT: This kit travels with the FORCE-801, FORCE-802, and FORCE-804, should you decide to participate in more than one, there is an additional $100 fee per ILC/PT

Participants will use their lab practices to perform 8 measurements of compression in the range of 2.5 Klb to 25 Klb. Measurement values will be appropriate for calibration of similar devices. The output is read directly with a ratio voltmeter in mV/V. The expected uncertainty will vary depending on the calibration equipment used. The expected uncertainty will be in the range of 0.0003 mV/V to 0.004 mV/V.

Participants are expected to be familiar with and have appropriate lab equipment and measurement uncertainties for the calibration of similar devices.

**TRAVEL KIT: This kit travels with the FORCE-802, FORCE-803, and FORCE-804, should you decide to participate in more than one, there is an additional $100 fee per ILC/PT.

Participants will use their lab practices to perform 5 measurements of tension and 5 measurements of compression between 10 and 100 lbf. Measurement values will be appropriate for calibration of similar devices.

Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.

It will read directly in engineering units over the range of 100 to 1000 lbf. The associated uncertainty is expected in pounds and varies with set point and setup method over this range. This ILC/PT Kit contains a 1000 lb Load Cell with Digital Indicator.

Participants will use their lab practices to perform 6 measurements of force. Measurement values will be appropriate for calibration of similar devices. 

Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.

Participants will use their lab practices to perform 16 displacement measurements ranging from 0.020 in to 0.080 in with forces from 40 gf to 4533 gf. Test methods and test reporting are based on ASTM D2240 industry requirements. Measurement values will be appropriate for calibration of similar devices. 

Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.